1. Remove the top shelf.If the top shelf, which is located below the water filter, is in the highest position, it will need to be removed. This can be done in two simple steps:
- Tilt up the front of the shelf and lift it.
- Pull the shelf out.
2. Remove old water filter.
Pull the old water filter downward and turn it counter-clockwise to pull it out.
Make sure to rotate the filter down completely before pulling it out of the manifold hole.
3. Install new water filter.
Take a new water filter out of its packaging and remove the protective cover from the o-rings.
With the filter tabs in the horizontal position, push the new filter into the manifold hole, rotate it up into place, and close the cover.
4. Remove trapped air.
Now that the filter is replaced, dispense 2.5 gallons of water to remove trapped air and contaminants from the system.
Depress and release the dispenser pad for cycles of 30 seconds ON and 60 seconds OFF, rather then dispensing continuously.
If your model is equipped with a water filter indicator on the display, press and hold the FILTER button
or RESET button for approximately 5 seconds to reset the filter indicator.
SPECIFICATION
- Type: Horizontal
- Flow Rate: 0.5 gpm (1.9 lpm)
- Capacity: 200 gallons (757 litres)
- Temperature: 33-100°F (0.6-37.8°C)
- Pressure: 20-120psi (138-827 kPa)
- Function: Chemical/Mechanical
- Service Life: 6 months
DIMENSIONS
Gross Width (inches): 2.1"
Gross Depth (inches): 2.1"
Gross Height (inches): 7.1"
Gross CBM: 0.00051
Product Weight: .39 lbs